The selection, installation, and maintenance of cantilever beam sensors significantly impact their measurement accuracy and lifespan. When selecting a sensor, the range should be chosen based on the project's maximum load, and a 30% safety margin is recommended to avoid overload damage. For dynamic load scenarios, the sensor's fatigue life must be considered. The accuracy class should be selected according to application requirements, such as OIML Class C or D. Accuracy is typically characterized by parameters such as nonlinearity and hysteresis error. For laboratory projects, a 0.05%FS high-precision sensor can be used, while 0.5%FS is sufficient for industrial applications. Environmental factors such as humidity, dust, corrosion, and temperature must be considered when selecting the protection level, such as IP65 or IP67, as well as the material, such as alloy steel or stainless steel. Special materials are required for high-temperature environments (>150 stopinj), nerjaveče jeklo s prevleko pa je treba uporabljati v zelo korozivnih okoljih.
Način namestitve je mogoče izbrati glede na zahteve projekta, kot so stopničaste pozicionirne luknje, snemljivi priključki ali navojni vmesniki. Izhodni signal mora biti združljiv s sistemom zajemanja; analogni signali imajo močne-zmožnosti proti motnjam, medtem ko so digitalni signali primerni za-prenos na dolge razdalje. Za povezavo z računalnikom ali PLC-jem je mogoče izbrati digitalni senzor z vgrajenim-analogno-v-digitalnim pretvornikom. Za izravnavo-obremenitve zunaj središča med namestitvijo so zaželeni senzorji z vgrajenimi-komponentami za prenos sile z jekleno kroglo ali strukturami z dvojno kroglično glavo. Ti senzorji odpravljajo-napake pri nalaganju izven središča prek krogličnih utorov in vzmetnih sistemov, kar poenostavi namestitev in odpravljanje napak.